You have no items in your shopping cart.

Replacement Parts

View as Grid List
Sort by
Display per page
Complete Foot Assembly 8" or 12" pad | All German Motorsports

AGM Complete Jacking System Foot Assembly

  • Complete foot assembly with 8" diameter Baja pad (dished) or 12" diameter Dakar pad (flat).


NOTE: Priced as each, individually for single unit orders. Two required per vehicle.

Jacking System Pad -ONLY- | All German Motorsports

Jacking System Pad -ONLY-


    Replacement 8" diameter Baja pad (dished)


    Replacement 12" diameter Dakar pad (flat)

    NOTE: Sold without foot assembly. Priced as each, individually for single unit orders.

    Two required per vehicle.

Picture of Service Wrench

Service Wrench

  • This special tool aids in the assembly and disassembly of each AGM Jack. Made of lightweight aluminum, anodized in satin black featuring a clamping end and a spanner wrench. This special tool is a must-have for any racer equipped with an AGM Jacking System.


NOTE: Service wrenches are priced as each individually for single unit orders.  

Both the 2" and 2 3/4" wrenches are required for proper assembly. 


Picture of Jack Assembly Reseal Kit

Jack Assembly Reseal Kit


Jack Assembly Reseal Kit includes seals and gland necessary to rebuild one (1) jack assembly.


Note: Two (2) kits required per vehicle



Picture of Jack Plug Valve

Jack Plug Valve

  • An accessory to the jacking system. When installed inline on the "extend" side of the jack assembly plumbing, closing this valve will isolate the fluid in the Jack Assembly. This is very useful as it allows the jacks to remain "extended" with the engine off for an indefinite period of time. Great for addressing major repairs in the field that require immediate attention, or servicing your vehicle in the pits or at the shop.
Picture of Hydraulic Line Kit

Hydraulic Line Kit

  • Hydraulic Line Kit includes 30 feet of high-pressure hose, -4AN hose fittings to connect the control manifold to the jack assemblies (4 straight, 2 90-degree short and 2 90-degree long fittings).
Upper Chassis Mounts |

Upper Chassis Mounts

  • The Upper Chassis Mount is designed to affix the top the Jack assembly to the Chassis and bear the majority of the lifting load.

  • The mount is overbuilt with additional material to allow the end-user to machine down the mount as they see fit to accommodate their chassis design and jack assembly configuration.  


NOTE: The chassis mount is individually priced as each, for single unit orders.  
Two chassis mounts are required (1 per jack assembly)